Specifications

19-14 wlans Commands
Examples
ThefollowingexampleenablestheinclusionofAPIdentificationinformationinmessagestothe
RADIUSserver:
EWC.enterasys.com:wlans:test:auth# auth-ap enable
EWC.enterasys.com:wlans:test:auth# apply
EWC.enterasys.com:wlans:test:auth# show auth-ap
AP as VSA attribute: enable
19.6.5.3 auth-egress
Usetheauth‐egresscommandtoincludeegressratecontrolinformationinthemessagetothe
RADIUSserver.Theauth‐egresscommandisaccessiblefromthewlan:<WLAN‐service‐
name>:authcontextoftheCLI.
Syntax
auth-egress enable | disable
Parameters
Usage
Theauth‐egresscommandisnotavailablewhentheauthenticationmodeisguestportal.Whenthe
authenticationmodeisdisabled,MACmustbeenabledforthiscommandtobeavailable.For
moreinformation,see“mode”onpage 19‐32.
Examples
Thefollowingexampleenablestheinclusionofegressratecontrolinformationinmessagestothe
RADIUSserver:
EWC.enterasys.com:wlans:test:auth# auth-egress enable
EWC.enterasys.com:wlans:test:auth# apply
EWC.enterasys.com:wlans:test:auth# show auth-egress
Egress rate control as VSA attribute: enable
Note: After you run the auth-ap command, you must run the apply command to implement the
changes.
enable|disable Specifiestoenableordisabletheinclusionofegressrate
controlinformationinmessagestotheRADIUSserver
Note: After you run this command, you must run the apply command to implement the changes.