Specifications

Enterasys Wireless Controller Software CLI Reference Guide 19-13
• protocol
• remove
• show
19.6.5.1 aaa-redir
Usetheaaa‐redircommandtoenableordisableAAAredirect.
Syntax
aaa-redir enable | disable
Parameters
Usage
The8021xauthenticationmodemustbesetforthiscommandtobeavailable.Formore
information,see“mode”onpage 19‐32.
Examples
ThefollowingexampleenablesAAAredirect:
EWC.enterasys.com:wlans:cnl-AAA:auth# aaa-redir enable
EWC.enterasys.com:wlans:cnl-AAA:auth# apply
19.6.5.2 auth-ap
Usetheauth‐apcommandtoincludeAPIdentificationinthemessagetotheRADIUS server.The
auth‐apcommandisaccessiblefromthewlan:<WLAN‐service‐name>:authcontextoftheCLI.
Syntax
auth-ap enable | disable
Parameters
Usage
Theauth‐apcommandisnotavailablewhentheauthenticationmodeisguestportal.Whenthe
authenticationmodeisdisabled,MACmustbeenabledforthiscommandtobeavailable.For
moreinformation,see“mode”onpage 19‐32.
enable|disable SpecifytoenableordisableAAAredirect
Note: After you run the aaa-redir command, you must run the apply command to implement the
changes.
enable|disable SpecifiestoenableordisabletheinclusionofAP
IdentificationinformationinmessagestotheRADIUSserver