Specifications

19-10 wlans Commands
Examples
ThefollowingexampleaddsanAPbyserialnumbertotheWLANservicenamed“test”andthen
displaysthelistofWirelessAPs:
EWC.enterasys.com:wlans:test# aplist 0500000000000000 both
EWC.enterasys.com:wlans:test# apply
EWC.enterasys.com:wlans:test# show aplist
Wireless AP Services:
Wireless AP: 0500000000000000 both
19.6.3 aplist-wds (WDS)
Usetheaplist‐wdscommandtoaddorremoveanAPtoorfromaWDStypeWLANservice
configuration.Theaplist‐wdscommandisaccessiblefromthewlans:<WLAN‐service‐name>
contextoftheCLIwhentheWLANservicetypeisWDS.
Referto“19.6.4 aplist‐wds(Mesh)”onpage 19‐11
forinformationabou tusingthecommandto
configureadynamicmeshWLANservice.
Usethiscommandtoconfigurethefollowing:
•Roleonradio1
•Roleonradio2
• Preferredparent
• Backupparent
•Workgroupbridging
Syntax
aplist-wds <ap-name> ((radio1 <none|child|parent|both> radio2
<none|child|parent|both>)|(both <none|child|parent|both>)) [pref-parent <ap-name
| Any-Parent>] [backup-parent <ap-name | Any-Parent>] [wkgbridge <on|off>]
no aplist-wds <ap-name> radio1|radio2|both
Parameters
Note: After you run the aplist command, you must run the apply command to implement the
changes.
radio1<none|child|parent|
both>
SpecifiestheAP’sroleonRadio1
radio2<none|child|parent|
both>
SpecifiestheAP’sroleonRadio2
both<none|child|parent|
both>
SpecifiestheAP’sroleonbothradios
pref‐parent<ap‐name|Any
Parent>
Specifiesthe
AP’sparent
backup‐parent<ap‐name|
AnyParent>
SpecifiestheAP’sbackupparent
wkgbridge<off|on> Configurestheworkgroupbridging