Specifications

Enterasys Wireless Controller Software CLI Reference Guide 19-1
19
wlans Commands
ThissectiondescribescommandsusedtodefineandconfigureWLANservicesforthenetwork.
ThesecommandsarelocatedinthewlanscontextoftheCLI.Executethewlanscommandatthe
rootleveltoenterwlanscontext.
Thefollowingcommandsareavailableinthewlanscontext:
• clients—Seeclientsfor
commandsinthewlan:clientscontext.
• create
• delete
• remote‐ssid
• show
• <WLAN‐service‐name>—See<WLAN‐service‐name>forcommandsinthewlan:<WLAN‐
service‐name>context.
19.1 clients
Theclientscontextprovidescommandswhichareusedtoconfigureguestaccessfeaturesonthe
EnterasysWirelessController.Switchtotheclientscontextfromthewlanscontexttoaccessthe
followingcommandsontheEnterasysWirelessController.
Thefollowingcommandsareavailableinthe
wlan:clientscontext.
• client
• descr
• enable
• endofday
• export_clients
Note: All CLI commands cache changes. For this reason, sometimes when you make a change in a
particular context, the change may not be visible immediately. If this happens, you must exit and re-
enter the context in order to ensure that the database is synchronized with the latest change.
Note: The wlans context was introduced with V7R0.
Note: A guest portal WLAN service must be created on this controller before the clients context
command and the context's associated commands are available. For more on creating a guest
portal WLAN service, see “mode” on page 19-32.