Specifications

Enterasys Wireless Controller Software CLI Reference Guide 18-35
18.8.1 auth
Usetheauthcommandtoassignadefaultpolicyforauthenticatedclients.Thiscommandis
availablefromthevnsmode:<named‐VNS>context.
Syntax
auth {non-auth | <policy-name>
Parameters
Usage
WhenyouassignadefaultauthenticatedpolicytothisVNS,thesamerulesapplyaswhenaVNS
iscreated.Thatis—iftheVNS’sWLANServicehasamodeof:
•“std”thenthereferencedpolicymusthaveatopologyofmode“b@ap,”“b@ac,”or“routed”
• “3pap”thenthereferencedpolicy
musthaveaphysicaltopologymode
•“wds”thenthereferencedpolicymusthaveanulltopology
Examples
Thefollowingexamplespecifiesthatthepolicynamed“auth‐users”shouldbeusedasthedefault
policyforauthenticatedusersfortheVNSnamedVNS1.
EWC.enterasys.com:vnsmode:VNS1# auth auth-users
Thisexamplespecifiesthatthesamepolicyusedasthedefaultpolicyfornon‐authenticatedusers
shouldbeusedforauthenticatedusersfor theVNSnamedVNS1.
EWC.enterasys.com:vnsmode:VNS1# auth non-auth
EWC.enterasys.com:vnsmode:VNS1# apply
18.8.2 non-auth
Usethenon‐authcommandtochangethedefaultpolicyfornon‐au thenticatedclients.This
commandisavailablefromthevnsmode:<named‐VNS>context.
Syntax
non-auth <policy-name>
Parameters
non‐auth Usethedefaultpolicyfornon‐authenticated clientsfor
authenticatedclients.
<policy‐name> Specifiesthenameofthepolicytouseasthedefaultpolicy
forauthenticatedclients.
Note: After you run the auth command, you must run the apply command to implement the
changes.
<policy‐name> Specifiesthenameofthepolicytouseasthedefaultpolicy
fornon‐authenticatedclients.