Specifications

Enterasys Wireless Controller Software CLI Reference Guide 18-7
Ingress rate profile: Unlimited
Egress rate profile: Unlimited
Enable AP filtering: enable
Synchronize: disable
EWC.enterasys.com:vnsmode:default-policy#
18.4.2 sync
Usethesynccommandtoenableordisableautomaticsynchronizationofthedefault‐policyacross
pairedcontrollers.RefertotheEnterasysWirelessControllerUserGuideformoreinformation
aboutsynchronizationofpolicies.
Thesynccommandisaccessiblefromwithinthevnsmode:default‐policycontext.
Syntax
sync {enable | disable}
Parameters
Examples
Thefollowingexampleenablesthesynchronization ofthedefault‐policyacrosscontrollers:
EWC.enterasys.com:vnsmode:default-policy# sync enable
EWC.enterasys.com:vnsmode:default-policy# apply
EWC.enterasys.com:vnsmode:default-policy# show
Assigned topology: Bridged at AP untagged
Ingress rate profile: Unlimited
Egress rate profile: Unlimited
Enable AP filtering: disable
Synchronize: enable
EWC.enterasys.com:vnsmode:default-policy#
18.4.3 acfilters
Usetheacfilterscommandtoenterthevnsmode:default‐policy:acfilterscontextforthe
configuringofdefault‐policyACfilters.Theacfilterscommandisaccessiblefromwithinthethe
vnsmode:default‐policycontext.
ACfilterrulesareappliedatthecontroller.Default‐policyACfilterconfigurationisapplied when
noACfiltersareconfigured
forpolicyappliedatthecontroller.
Thefollowingcommandsareavailableinthevnsmode:default‐policy:acfilterscontext:
• create
enable|disable Enablesordisablessynchronizationofthedefault‐policyacross
controllers.
Notes: AC filtering is not available when the associated topology is configured for Bridge at AP. AC
filtering is available when the associated topology is set to either Bridge at AC or Routed.
The acfilter command has been replaced by acfilters. acfilter is deprecated.