Specifications

18-6 VNS Commands (vnsmode)
18.4 default-policy
Thedefault‐policycommandmovesyouintothevnsmode:default‐policycontext.The
vnsmode:default‐policycontextprovidescommandsfortheconfigurationofthedefault‐policy.
Thedefault‐policydefinitionsprovideaplaceholderforcompletionofincomplete(no‐change)
policiesfortheVNSbeingconfigured.RefertoChapter 20,policyCommandsforacomplete

discussionofpolicycommands.
Thedefault‐policyspecifies:
•AtopologytousewhenaVNSiscreatedusingapolicy(non‐authpolicy)thatdoesnot
specifyatopology.ThedefaultassignedtopologyistheBridgeTrafficLocallyatAPtopology.
•Aninboundandoutboundratecontrolprofile.Thedefaultratecontrol
profileis“Unlimited”.
•Asetoffilters.Thedefaultfiltersetisasingledenyallrule.
Thefollowingcommandsareavailableinthevnsmode:default‐policycontext:
• show
• sync
• acfilters—Seeacfiltersforcommandsinthe vnsmode:default‐policy:acfilterscontext.
• rateprf‐in
• rateprf‐out
• topology‐name
• ulfilterap
• apcustom
• apfilters—See
apfiltersforcommandsinthevnsmode:default‐policy:apfilterscontext.
18.4.1 show
Usetheshowcommandtodisplaythedefault‐policyconfigurationinformationforthecurrent
vnsmode:default‐policycontext.Theshowcommandisaccessiblefromwithinthethe
vnsmode:default‐policycontext.
Syntax
show
Parameters
None.
Examples
Thefollowingexampledisplaysthedefault‐policyconfigurationfromwithinthe
vnsmode:default‐policycontext:
EWC.enterasys.com:vnsmode:default-policy# show
Assigned topology: Bridged at AP untagged
Note: After you have completed configuration changes for the default-policy, you must run the
apply command before exiting the vnsmode:default-policy context to implement the changes.