Specifications

18-4 VNS Commands (vnsmode)
18.1.5 max-voice-reassoc
Usethemax‐voice‐reassoccommandtosetthemaximumallowedoverallbandwidthonthenew
APwhenaclientwithanactivevoicestreamroamstoanewAPandrequestsadmissionforthe
voicestream.
Syntax
max-voice-reassoc <0-100>
Parameters
Examples
Thefollowingexamplesetsthemaximumvoicebandwidthforroamingstreamsto80%
EWC.enterasys.com:vnsmode:adminctr# max-voice-reassoc 80
18.2 create
UsethecreatecommandtocreateanewVNS.Thiscommandisavailableinthevnsmodecontext.
AfteryoucreateaVNSwiththiscommand,youcanconfigureadditionalparametersinthe
vnsmode:<named‐VNS>context.Referto“<named‐VNS>”onpage 18‐34formoreinformation.
Syntax
create <vns name> wlans <WLANS name> pol <policy name>
Parameters
Usage
WhenyoucreateaVNS,ifthereferencedWLANServicehasamodeof:
•“std”thenthereferencedpolicymusthaveatopologyofmode“b@ap,”“b@ac,”or“routed”
• “3pap”thenthereferencedpolicymusthaveaphysicaltopologymode
•“wds”thenthereferencedpolicymusthaveanulltopology
Examples
ThefollowingexamplecreatesaVNSnamedtestvnsand assignsitaWLANServicenamed
“HWC‐1”andapolicynamed“NonAuth.”
EWC.enterasys.com:vnsmode# create testvns wlans HWC-1 pol NonAuth
<0‐100> Specifiesthemaximumallowablebandwidthasapercentageoftotal
bandwidth.
Note: After you run the max-voice-reassoc command, you must run the apply command to
implement the changes.
<vnsname> SpecifiesanameforthisVNS
wlans<WLANSname> SpecifiesaWLANServiceforthisVNS
pol<policyname> Specifiesthenon‐authenticationpolicyforthisVNS