Specifications

16-4 traffic_capture Commands
16.6 list
Usethelistcommandtodisplaythe“TCPDumpfilecapture”list.The listcommandisaccessible
fromthetraffic_capturecontextoftheCLI.
Syntax
list
Parameters
None
Examples
ThefollowingexampledisplaysthelistofTCPDumpfilecapture.
EWC.enterasys.com:traffic_capture# list
Traffic Capture Files:
1:mgmt_traffic_dump.cap
2:mgmt_traffic_dump.cap (flash)
3:mgmt_traffic_dump-01.cap (flash)
4:mgmt_traffic_dump-02.cap (flash)
5:dhcp-relay-01.cap (flash)
6:third-party-01.cap (flash)
7:mgmt_traffic_dump-03.cap (flash)
16.7 start
Usethestartcommandtostartcapturingtheexceptiontraffictoandfromthemanagementplane.
Thecaptureincludesthefollowing:
•Alltrafficonthemanagementport(eth0)
•ExceptiontrafficforthephysicalesaportsanddefinedVNS
Thestartcommandisaccessiblefromthetraffic_capturecontextoftheCLI.
Syntax
start
Parameters
None
Examples
Thefollowingexamplespecifies tostartcapturingtheexceptiontraffic.
Note: The files that are stored on the CF card have flash suffixed to their file names. For example,
mgmt_traffic_dump.cap (flash).
The files that are stored on the local drive of the controller do not have anything suffixed to them.
Note: You can save only one TCPDump file on the local drive.