Specifications

Enterasys Wireless Controller Software CLI Reference Guide 16-3
16.4 interface
Usetheinterfacecommandtospecifytheinterfaceonwhichtheexceptiontrafficistobe
captured.
Syntax
interface <interfacename>
Parameters
Parameters
None
Examples
Thefollowingexamplespecifies theexceptiontraffictobecapturedonesa0.
EWC.enterasys.com:traffic_capture# interface esa0
16.5 delete
UsethedeletecommandtodeletetheTCPDumpfile.Thedeletecommandisaccessiblefromthe
traffic_capturecontextoftheCLI.
Syntax
delete <# from the capture file list>
Parameters
Examples
Thefollowingexamplespecifies thefile#1inthe“TCPDumpfilecapture”listtobedeleted.
EWC.enterasys.com:traffic_capture# delete 1
Note: The destination command is accessible only in the Enterasys Wireless C2400 Controller and
only when the CF card is enabled.
Note: You can choose any of the following interfaces:
• Management Port (eth0)
• Physical esa ports
• Defined VNS
<interfacename> Theinterfacenameonwhichtheexceptiontrafficistobe
captured
<#fromthecapturefilelist> Thesequenceinwhichthefilesarelistedinthecapturefilelist
Note: To display the “TCPDump file capture” list, you must run the list command from the
traffic_capture context of the CLI. For more information, see the following section.