Specifications

Enterasys Wireless Controller Software CLI Reference Guide 15-1
15
time Commands
NetworkelementsontheEnterasysWirelessControllercan besynchronizedtoauniversalclock
inoneoftwoways:
•usingtheEnterasysWirelessController’sownsystemtime
•usingtheNetworkTimeProtocol
Thecommandsdescribedinthissectionareusedtoselectandconfiguretheseoptions,andare
locatedinthetime
contextoftheCLI.
Thefollowingcommandsareavailableinthetimecontext:
• clock
• date
• ntp
• ntpip
• tz
15.1 clock
Usetheclockcommandtosetthesystemtime.
TheNetworkTimeProtocolmustbedisabledbeforethiscommandcanbeused.Formore
information,see“ntp”onpage 15‐2.
Syntax
clock <hh:mm>
Parameters
Note: All CLI commands cache changes. For this reason, sometimes when you make a change in a
particular context, the change may not be visible immediately. If this happens, you must exit and re-
enter the context in order to ensure that the database is synchronized with the latest change.
Note: After you run the following time commands, you must run the apply command to implement
the changes.
hh Specifiesthecurrenthour(in24hourclock format)
mm Specifiesthecurrentminute