Specifications

Enterasys Wireless Controller Software CLI Reference Guide 13-1
13
snmp Commands
TheEnterasysWirelessControllersupportstheSimpleNetworkManagementProtocol(SNMP)
forretrievingstatisticsandconfigurationinformation.
ThissectiondescribescommandswhichmanageSNMPsettingsfortheEnterasysWireless
Controller.ThesecommandsarelocatedinthesnmpcontextoftheCLI.
Thefollowingcommandsareavailableinthesnmpcontext:
• contact
• context
• enable
• engine‐id
• location
• severity
• trap‐manager‐v1v2
• trap‐manager‐v3
• user
• show
• rwcommunity
• port
• publish‐ap
• show
13.1 contact
UsethecontactcommandtoidentifythenameoftheSNMPadministrator.
Syntax
contact <string>
Parameters
Note: All CLI commands cache changes. For this reason, sometimes when you make a change in a
particular context, the change may not be visible immediately. If this happens, you must exit and re-
enter the context in order to ensure that the database is synchronized with the latest change.
<string> SpecifiesthenameofthepersonenablingSNMPtrapsonthesystem