Specifications

Enterasys Wireless Controller Software CLI Reference Guide 10-3
Examples
ThefollowingexampleenablesSLPregistration
EWC.enterasys.com:mobility# splreg
10.5 agent
Usetheagentcommandtoadd,remove,orapproveanagentonthenetworkbyitsIPaddress.
Syntax
agent (add|remove|approve) <IP Address>
Parameters
Examples
Thefollowingexampleaddsanagenttothenetwork
EWC.enterasys.com:mobility# agent add 10.0.0.1
Thefollowingexampleremovesanagentfromthe network
EWC.enterasys.com:mobility# agent remove 10.0.2.4
Thefollowingexampleapprovesanagentonthenetwork
EWC.enterasys.com:mobility# agent approve 10.0.0.1
10.6 secmode
UsethesecmodecommandtosettheSecurityModetoallowonlyapprovedAgentstoconnectto
themanager,orallowallagentstoconnect.
Syntax
secmode (approved|none)
Parameters
Note: The role of the Enterasys Wireless Controller must be set to Manager before this option
becomes available. For more information, see “mrole” on page 10-1.
add Addsan agenttothenetwork
remove Removesanagentfromthenetwork
approve Approvesanagentonthenetwork
<IPAddress> SpecifiestheIPaddressoftheagent
approved Allowsonlyapprovedagentstoconnecttothemanager
none Allowsallagentsaretoconnecttothemanager