Specifications

Enterasys Wireless Controller Software CLI Reference Guide 9-5
Parameters
None
Examples
ThefollowingexamplesetsthechanneldwelltimeofscangroupSouthBlockto100milliseconds.
EWC.enterasys.com:mitigator:scgroup:South Block# dtime 100
9.3.2.4 radio
Usetheradiocommandtomodifytheradiomodetobeusedforscanning.
Syntax
radio <radio1|radio2|both>
Parameters
Examples
Thefollowingexamplesetsradio1tobeused.
EWC.enterasys.com:mitigator:scgroup:South Block# radio1
9.3.2.5 type
Usethetypecommandtomodifythescantype—activeorpassive.
Syntax
type active|passive
Parameters
Examples
Thefollowingexamplesetsthescantypetoactive.
EWC.enterasys.com:mitigator:scgroup:South Block# type active
Note: After you have run the dtime command, you must run the apply command to start the
scanning.
radio1 Specifiesradio1tobeused
radio2 Specifiesradio2tobeused
both Specifiesbothradio1andradio2
Note: After you have run the radio command, you must run the apply command to start the
scanning.
active Specifiesactivetypescanning
passive Specifiespassivetypescanning