Specifications

9-4 mitigator Commands
• show
9.3.2.1 aplist
UsetheaplistcommandtomodifythelistoftheWirelessAPthatarepartofthescangroup.Use
thenoformofthecommandtodeletetheWirelessAPsfromthelist.
Syntax
[no] aplist <serial>...
aplist <serial>...
Parameters
Examples
ThefollowingexampleaddstheWirelessAPsofthefollowingserialnumberstothescangroup:
500006072051354and0500006072051427.
EWC.enterasys.com:mitigator:scgroup:South Block# aplist 500006072051354
0500006072051427
9.3.2.2 interval
Usetheintervalcommandtomodifythescantimeintervalinminutes.Validvaluesarefrom10to
120minutes.
Syntax
interval <period>
Parameters
Examples
Thefollowingexamplemodifiesthescantimeintervalto30minutes.
EWC.enterasys.com:mitigator:scgroup:South Block# interval 30
9.3.2.3 dtime
UsethedtimecommandtomodifytheChannelDwellTimeofthescangroup.
Syntax
dtime <1-1000>
<serial...> SpecifiestheWirelessAPbytheirserialnumbersthataretobe
addedtothescangroup
Note: After you have run the aplist command, you must run the apply command to start the
scanning.
<period> Specifiesthescantimeintervalperiodinminutes
Note: After you have run the interval command, you must run the apply command to start the
scanning.