Specifications

Enterasys Wireless Controller Software CLI Reference Guide 9-3
9.3.1 sgname
Usethesgnamecommandtocreateascangroup.Usethenoformofthecommandtodeletethe
scangroup.Thesgnamecommandisaccessiblefromthemitigator:scgroupcontextoftheCLI.
Syntax
sgname <scan group name> <10-120> [dtime <1-1000>] [radio1 |radio2|both] [channel
all|current] [type active|passive] [serial <serial>...]
no sgname <scan group name>
Parameters
Examples
ThefollowingexamplecreatesascangroupnamedSouth‐Block.
EWC.enterasys.com:mitigator:scgroup# sgname South-Block 100 dtim 300 radio both
channel all type active serial 0500006072051354 0500006072051427 0500006062051048
0500006062051040
9.3.2 <scan group name>
The<scangroupname>isacontext,whichcontainscommandstomodifytheattributesfora
specifiedscangroup,wheretheparameter<scangroupname>referstothescangroupʹsname.
The<scangroupname>commandisaccessiblefromthemitigator:scgroupcontextoftheCLI.
Thefollowingcommandsareavailable
inthethemitigator:scgroup:<scangroupname> context:
• aplist
• interval
• dtime
• radio
• type
• channel
• start
scangroupname Specifiesthescangroupname
10‐20 Specifiesthescantimeinterval
dtime<1‐1000> SpecifiestheChannelDwellTimeofthescangroup
radio1|radio2|both Specifiesradios—radio1,radio2,orboth
channelall|current Specifiesthechannelstobe
scanned—allorcurrent
typeactive|passive Specifiesthescantype—activeorpassive
serial SpecifiestoaddtheWirelessAPsbytheirserialnumberstothescan
group.
<serial> SpecifiestheserialnumberoftheWirelessAP sthataretobeaddedto
thescangroup
Note: After you have added the Wireless APs to the scan group, you must run the apply command
to implement the changes.