Specifications

7-6 ip Commands
7.2.5.4 deadinterval
UsethedeadintervalcommandtosettheamountoftimetheOSPFprotocolwillwaitfora
responsebeforeassumingpeerdevicesareunreachable.
Syntax
deadinterval <1-65535>
Parameters
Examples
Thefollowingexamplesetsthetimetowaitforapacketresponseto300seconds
EWC.enterasys.com:ip:ospf:ospfinterface:0# deadinterval 300
7.2.5.5 hellointerval
UsethehellointervalcommandtospecifythetimeintervalbetweenthetransmissionofOSPF
Hellopacketstodevicesonthenetwork.
Syntax
hellointerval <1-65535>
Parameters
Examples
Thefollowingexamplesetsthetimeintervalbetweenoutgoingpacketsto10seconds
EWC.enterasys.com:ip:ospf:ospfinterface:0# hellointerval 10
7.2.5.6 linkcost
UsethelinkcostcommandtoassignaLinkCosttotheport.
Syntax
linkcost <1-65535>
Parameters
Examples
ThefollowingexamplesetstheLinkCostoftheportto10
EWC.enterasys.com:ip:ospf:ospfinterface:0# linkcost 10
<1‐65535> Specifiesthetimeinterval(inseconds)theOSPFprotocolwillwaitfor
aresponse
<1‐65535> Specifiesati me intervalinseconds
<1‐65535> Specifiesanumericalvalue