Specifications

Enterasys Wireless Controller Software CLI Reference Guide 7-5
Parameters
None.
Examples
Thefollowingmovesyoutotheip:ospf:ospfinterface:0contextfortheconfigurationOSPF
interfaceesa0.
EWC.enterasys.com:ip:ospf:ospfinterface# 0
EWC.enterasys.com:ip:ospf:ospfinterface:0#
7.2.5.2 authkey
Usetheauthkeycommandtosetthe passwordusedforauthentication.Usethenoformofthe
commandtoclearthepassword.
Syntax
authkey <password>
no authkey
Parameters
Examples
Thefollowingexamplesetsanauthenticationpassword
EWC.enterasys.com:ip:ospf:ospfinterface:0# authkey hello123
7.2.5.3 authtype
Usetheauthtypecommandtoindicate whethertheauthenticationwillrequireapasswordornot.
Syntax
authtype (none|password)
Parameters
Examples
Thefollowingexampleconfiguresauthentication torequireapassword
EWC.enterasys.com:ip:ospf:ospfinterface:0# authtype password
Note: Authentication must be configured to use a password before this command can be used. For
more information, see “authtype” on page 7-5.
<password> Specifiesthepasswordusedforauthentication
none Indicatesthatnopasswordisrequired
password Indicatesthatauthenticationwillrequireapassword