Specifications

Enterasys Wireless Controller Software CLI Reference Guide 5-1
5
checkpoint Commands
TheEnterasysWirelessControllerforwardsspecifiedeventmessagestoanELAserverusing
CheckPointsoftware’sOPSECELAprotocol.Theservertracksandanalyzestheseeventmessages
andforwardssuspiciousinformationtoafirewallapplication.
ThissectiondescribescommandswhichenableandconfigureCheckPointeventloggingoptions
fortheEnterasys
WirelessController.Thesecommandsarelocatedinthecheckpointcontextof
theCLI.
Thefollowingcommandsareavailableinthecheckpointcontext:
• cpip
• cplog
• cpcert
• elalogint
• elaport
• elaq
• elaretry
• sicname
• sicpwd
5.1 cpip
Usethecpipcommandtosetthe IPaddressoftheELAManagementStation.
SuspiciousmessagestrackedbytheELAserveraresenttothefirewalloftheELAManagement
Station.
Syntax
cpip <IP Address>
Note: All CLI commands cache changes. For this reason, sometimes when you make a change in a
particular context, the change may not be visible immediately. If this happens, you must exit and re-
enter the context in order to ensure that the database is synchronized with the latest change.
Note: You must enable checkpoint logging before this command will become visible in the CLI. For
more information, see “cplog” on page 5-2.