Specifications

4-152 ap Commands
4.12.25 poll_timeout
Usethepoll_timeoutcommandtosettheamountoftimetheWirelessAPwillwaitforaresponse
timefromtheEnterasysWirelessControllerbeforerebooting.Thepoll_timeoutcommandis
accessiblefromtheap
:<serial>contextoftheCLI.
Syntax
poll_timeout <value>
Parameters
Examples
Thefollowingexamplesetsthepolltimeoutto10seconds.
EWC.enterasys.com:ap:0500008043050212# poll_timeout 10
4.12.26 port-setting
Usetheport‐settingcommandtosetthe duplexmodeandspeedoftheAP’sEthernetport.The
port‐settingcommandisaccessiblefromtheap
:<serial>contextoftheCLI.
Syntax
port-setting auto|((half|full) (10 | 100))
Parameters
Examples
ThefollowingexamplesetstheEthernetportontheAPtoauto.
EWC.enterasys.com:ap:0500008043050212# port-setting auto
4.12.27 radio1
Theradio1commandreferstotheradio1context,whichcontainscommandstoconfigureRadio1
oftheWirelessAP.Theradio1commandisaccessiblefromtheap
:<serial>contextoftheCLI.
Formoreinformationonradio1commands,seetheradio1commandsinsection“defaults”on
page 4‐4.
Note: The acceptable range for poll_timeout value is from 3 to 600.
<value> Specifiestheamountoftimeinsecondstowaitforaresponsefromthe
EnterasysWirelessControllerbeforerebooting.
auto Autonegotiatespeedandduplexmode
half|full Halforfullduplexmode
10|100 10Mbpsor100MbpsEthernet