Specifications

4-150 ap Commands
4.12.21 lldp
UsethelldpcommandtoenablethebroadcastoftheLLDPprotocolbyaWirelessAP.Usetheno
formofthecommandtodisableLLDP.Thelldpcommandisaccessiblefromtheap
:<serial>
contextoftheCLI.
Syntax
lldp <Announcement Interval> <Announcement Delay>
no lldp
Parameters
Examples
Thefo llowingexampleenablesLLDPforaWirelessAPwiththeserialnumber0409920201202222,
anannouncementintervalof30seconds,andanannouncementdelayof2.
EWC.enterasys.com:ap:0409920201202222# lldp 30 2
IfSNMPisenabledtopublishontheEnterasysWirelessControllerandyouenableLLDP,the
followingmessageisdisplayed:
WARNING: SNMP is set to publish. How Do you wish to continue?
(C) Cancel
(P) Proceed
(O) Disable SNMP publishing and proceed
Typeoneofthefollowing:
• C–CancelstheLLDPconfigurationandreturnstotheAPcontext.
• P–EnablesLLDPandmaintainsSNMPrunning
• O–EnablesLLDPanddisablesSNMPpublishing
4.12.22 move
UsethemovecommandtochangetherankofEnterasysWirelessControllersontheEnterasys
WirelessControllerlist.Themovecommandisaccessiblefromtheap
:<serial>contextoftheCLI.
Syntax
move aclist rank1 <+|-> rank2
Parameters
<AnnouncementInterval> Specifiesthescheduledfrequency,measuredinseconds,in
whichtheWirelessAPadvertisesitsinformationby
sendinganewLLDPpacket.
<AnnouncementDelay> Specifiesthedelay,measuredinseconds,between
successiveLLDPframetransmissionsthatisinitiatedbya
value/statuschangeintheLLDPlocalsystemsMIB.
<rank1> Specifiestherankofthelisteditemtobemoved
<+|‐>Moverankonepositionaboveorbelowtherank2item
<rank2> Specifiestherankoftheseconditem