Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-149
Parameters
Examples
ThefollowingexampleconfigurestheLEDmodetoindicateWDSsignalstrength:.
EWC.enterasys.com:ap:0409920201202222# led-mode wds-signal
4.12.20 location
UsethelocationcommandtosetthelocationstringforthespecifiedAP.Thelocationcommandis
accessiblefromtheap
:<serial>contextoftheCLI.
Syntax
location <location> | no location
Parameters
Usage
ThiscommandsupportstheuseofUnicode(UTF‐8)strings.Ifthelocationstringincludesmore
thanoneword,youmustenclosethestringindoublequotationmarks.
Examples
ThefollowingexamplesetsthelocationfortheWirelessAPas“2ndfloorsouth.”
EWC.enterasys.com:ap:0500008043050236# location "2nd floor south"
EWC.enterasys.com:ap:0500008043050236# apply
EWC.enterasys.com:ap:0500008043050236# show
host_name AP3620-0500008043050236
name 0500008043050236
desc
Location: 2nd floor south
identify AllLEDsblinksimultaneouslyapproximatelytwotofour
timeseverysecond.
normal IdentifiestheAPstatusduringtheregistrationprocess
duringpoweronandbootprocess.
off Displaysfaultpatternsonly.LEDsdonotlightwhentheAP
isfault‐freeandthediscoveryiscomplete.
wds‐signal I ndicatestheWDSsignalstrengthasa
bargraph.
ThissettinghelpstoalignexternalantennasinWDS
deploymentsbycorrelatingtheWDSlinkRSSwiththeLED
pattern.UsethissettingonlyiftheAPisparticipatingina
MeshorWDSnetwork.
<location> Assignanexistinglocationoranewlocation
nolocation Removethelocation