Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-131
Load Groups:
loadgroup1
loadgroup2
4.7 maintenance
ThemaintenancecommandallowsforupgradingaWirelessAP’ssoftwareimage.The
maintenancecommandisaccessiblefromtheapcontextoftheCLI.
4.7.1 upgrd
UsetheupgrdcommandtoupgradetheWirelessAP’ssoftwareimage.Theupgrdcommandis
accessiblefromtheap:maintenancecontextoftheCLI.
Syntax
upgrd <default|control>
Parameters
Examples
Thefollowingexamplespecifies defaultupgrade.
EWC.enterasys.com:ap:maintenance# upgrd default
Thefollowingexamplespecifies controlledupgrade.
EWC.enterasys.com:ap:maintenance# upgrd control
4.8 registration
Theregistrationcommandreferstocontextap:registration,whichdescribescommandsto
configureregistrationoptionsforconnectedWirelessAPs.
TheregistrationcommandisaccessiblefromtheapcontextoftheCLI.
Thefollowingcommandsareavailableintheap:registrationcontext:
• cluster‐encryption
• cluster‐inter‐ap‐roam
• cluster‐shared‐secret
<default> Specifiesdefaultupgrade.
Aspartofthedefaultupgradeprocess,
whentheWirelessAPregisterswiththecontroller,theAPʹsfirmware
versionisverified.Ifitdoesnotmatchwiththevalueasdefinedforthe
defaultimage,theAPisrequestedtoupgradetothedefaultimage.
<control> Specifiescontrolledupgrade.Thecontrolled
upgradeallowsyouto
individuallyselectandcontrolthestateofaWirelessAPimage
upgrade.Forexample,youcanspecifywhichWirelessAPtoupgrade,
theupgradeschedule,andhowtoupgrade.
Note: After you have run the upgrd command to upgrade the Wireless AP’s software image, you
must run the apply command.