Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-113
• radio_channels
4.3.6.9.4.1 channel_plan
Usethechannel_plancommandtocustomizethechannelplanfortheWirelessAP’sradio.The
channel_plancommandisaccessiblefromtheap:defaults:std:radio2:dcscontextoftheCLI.
Syntax
channel_plan <auto|3-channel|4-channel|channel[, channel]>
Parameters
Example
Thefollowingexampleshowsthatthechannelplanforradio2iscustomizedtoinclud e the
followingchannels:1,2and3.
EWC.enterasys.com:ap:defaults:std:radio2:dcs# channel_plan 1, 2, 3
4.3.6.9.4.2 mode
UsethemodecommandtosettheDCSmode.Themodecommandisaccessiblefromthe
ap:defaults:std:radio2:dcscontextoftheCLI.
Syntax
mode <off|monitor|active>
Parameters
Examples
ThefollowingexamplesetsDCStoactivemode.
EWC.enterasys.com:ap:defaults:std:radio2:dcs# mode active
Note: The parameters available in the channel_plan command are determined by the setting of
the mode command in the ap:defaults:std:radio2 context.
auto Radio2uses3channelsforcountriessupporting11channelsand4
channelsforcountriessupporting13channels
3‐channel Radio2uses3channels
4‐channel Radio2uses4channels
channel[,channel] Radio2usesthechannelsthatarelisted,separatedbycommas
off DisablesDCS
monitor Monitorsthenoiseandinterferenceonthecurrentchannel
active EnablesDCS
Note: In monitor mode, DCS generates an alarm and does not change the channel if the noise and
interference levels on the current channel exceed beyond their thresholds. In active mode, DCS
changes the channel if the noise and interference levels on the current channel exceed beyond
their thresholds.