Specifications

4-104 ap Commands
Parameters
Examples
ThefollowingexamplesetsDCStoactivemode.
EWC.enterasys.com:ap:defaults:std:radio1:dcs# mode active
4.3.6.8.4.3 radio_channels
Usetheradio_channelscommandtodisplaythelistofavailableradiochannelsforautochannel
selection(ACS).Theradio_channelscommandisaccessiblefromtheap:defaults:std:radio1:dcs
contextoftheCLI.
Syntax
radio_channels
Parameters
None
Examples
EWC.enterasys.com:ap:defaults:std:radio1:dcs# radio_channels
Available radio channels:
36: 5180 MHz
40: 5200 MHz
44: 5220 MHz
48: 5240 MHz
52: 5260 MHz
56: 5280 MHz
60: 5300 MHz
64: 5320 MHz
100: 5500 MHz
104: 5520 MHz
108: 5540 MHz
112: 5560 MHz
116: 5580 MHz
120: 5600 MHz
124: 5620 MHz
128: 5640 MHz
132: 5660 MHz
off DisablesDCS
monitor Monitorsthenoiseandinterferenceonthecurrentchannel
active EnablesDCS
Note: In monitor mode, DCS generates an alarm and does not change the channel if the noise and
interference levels on the current channel exceed beyond their thresholds. In active mode, DCS
changes the channel if the noise and interference levels on the current channel exceed beyond
their thresholds.