Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-97
4.3.5 learnac
UsethelearnaccommandtoallowtheWirelessAPtoprovideitsownEWCSearchList.Useno
formofthecommandtodisablethisfeature.Thelearnaccommandisaccessiblefromthe
ap:defaultscontextoftheCLI.
Syntax
learnac
no learnac
Parameters
None
Examples
ThefollowingexampleallowseachWirelessAPtoprovideitsownEWCSearchList.
EWC.enterasys.com:ap:defaults# learnac
4.3.6 std
Thestdcommandreferstocontextstd,whichcontainscommandstoconfigurethedefaultAP
settingsforthestandardWirelessAP.Thestdcommandisaccessiblefromtheap:defaultscontext
oftheCLI.
Thefollowingcommandsareavailableintheap
:defaults:stdcontext:
• bcast_disassoc
• client_session
• country
• led‐mode
• lldp
• poll_timeout
• radio1—Seeradio1forcommandsintheap:defaults:std:radio1context.
• radio2—Seeradio2forcommandsintheap:defaults:std:radio2context.
• telnet
4.3.6.1 bcast_disassoc
Usethebcast_disassoccommandtoenabletheWirelessAPtousebroadcastdisassociationwhen
disconnectingallclients,insteadofdisassociatingeachclientonebyone.Usethenoformofthe
Note: If you disallow the Wireless AP to provide its own EWC Search List, you should specify the
controller's static IP address by running the aclist command. For more information, see “aclist” on
page 4-146.
If you disallow the Wireless AP to provide its own EWC Search List and do not specify the
controller's static IP address, the Wireless AP will use the SLP to discover the controller.
Note: After you have run the learnac command, you must run the apply command to implement
the changes.