Specifications

4-96 ap Commands
Examples
ThefollowingexamplesetsthemaximumTxpowerlevelto18dBm.
EWC.enterasys.com:ap:defaults:dualband:radio2# tx_max_power 18
4.3.4.9.22 tx_min_power
Usethetx_min_powercommandtospecifytheminimumTxpowerlevel.Thetx_min_power 
commandisaccessiblefromtheap:defaults:dualband:radio2contextoftheCLI.
Syntax
tx_min_power <value>
Parameters
Examples
Thefollowingexamplespecifies theminimumTxpowerlevelto8dBm.
EWC.enterasys.com:ap:defaults:dualband:radio2# tx_min_power 8
4.3.4.10 telnet
UsethetelnetcommandtoenabletelnetaccesstotheWirelessAP.Usethenoformofthe
commandtodisableit.Thetelnetcommandisaccessiblefromthe ap:defaults:dualbandcontext
oftheCLI.
Syntax
telnet
no telnet
Parameters
None
Examples
ThefollowingexampleenablestelnetaccesstotheWirelessAP
EWC.enterasys.com:ap:defaults:dualband# telnet
Note: The tx_min_power is available only when Auto Tx Power Ctrl (ATPC) is enabled.
<value> SpecifiesthevalueindBm
Note: After you have run the telnet command, you must run the apply command to implement the
change.