Specifications

4-86 ap Commands
Parameters
Examples
Thefollowingexampleindicatesthatthechannelplanforradio2iscustomizedtoincludeallnon‐
DFSchannels.
EWC.enterasys.com:ap:defaults:dualband:radio2:dcs# channel_plan all-non-dfs
Thefollowingexampleshowsthatthechannelplanforradio2iscustomizedtoinclud e the
followingchannels:1,2and3.
EWC.enterasys.com:ap:defaults:dualband:radio2:dcs# channel_plan 1, 2, 3
4.3.4.9.4.2 mode
UsethemodecommandtosettheDCSmode.Themodecommandisaccessiblefromthe
ap:defaults:dualband:radio2:dcscontextoftheCLI.
Syntax
mode <off|monitor|active>
Parameters
Examples
ThefollowingexamplesetsDCStoactivemode.
EWC.enterasys.com:ap:defaults:dualband:radio2:dcs# mode active
Note: The parameters available in the channel_plan command are determined by the setting of
the mode command in the ap:defaults:dualband:radio2 context.
all‐non‐dfs Radio2usesallnon‐DFSchannels.
all Radio2usesallchannels
auto Radio2uses3channelsforcountriessup porting11
channelsand4channelsforcountriessupporting13
channels.
3‐channel Radio2uses3channels.
4‐channel Radio2uses4channels.
channel[,channel] Radio2usesthechannelsthatare
listed,separatedby
commas.
off DisablesDCS
monitor Monitorsthenoiseandinterferenceonthecurrentchannel
active EnablesDCS
Note: In monitor mode, DCS generates an alarm and does not change the channel if the noise and
interference levels on the current channel exceed beyond their thresholds. In active mode, DCS
changes the channel if the noise and interference levels on the current channel exceed beyond
their thresholds.