Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-73
4.3.4.8.3 beaconp
Usethebeaconpcommandtosettimeunitsbetweenbeacontransmissions.Thebeaconp
commandisaccessiblefromtheap
:defaults:dualband:radio1contextoftheCLI.
Syntax
beaconp <value>
Parameters
Examples
Thefollowingexamplesetsthetimebetweensuccessivebeaconsto70msonRadio1.
EWC.enterasys.com:ap:defaults:dualband:radio1# beaconp 70
4.3.4.8.4 dcs
Thedcscommandreferstothedcscontext,whichcontainscommandstoconfiguretheDynamic
ChannelSelection(DCS)feature.Thedcscommandisaccessiblefromthe
ap
:defaults:dualband:radio1contextoftheCLI.
Thefollowingcommandsareavailableintheap
:defaults:dualband:radio1:dcscontext:
• channel_plan
• mode
• noise_threshold
• occupancy_threshold
• radio_channels
• update_period
4.3.4.8.4.1 channel_plan
Usethechannel_plancommandtocustomizethechannelplanfortheWirelessAP’sRadio1.The
channel_plancommandisaccessiblefromtheap:defaults:dualband:radio1:dcscontextofthe
CLI.
Syntax
channel_plan <all-non-dfs|all|auto|3-channel|4-channel|channel
[, channel]>
<value> Specifiesthenumberoftimeunits(milliseconds)betweenbeacon
transmissions.Theacceptablerangeforbeaconpvalueisfrom50to
1000milliseconds.
Note: Commands entered in the dcs context do not need to be followed by "apply" in order for them
to take effect.
Note: The parameters available in the channel_plan command are determined by the setting of
the mode command in the ap:defaults:dualband:radio1 context.