Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-71
Examples
Thefollowingexampleenablesmodepersistence.
EWC.enterasys.com:ap:defaults:dualband# persistent
4.3.4.7 poll_timeout
Usethepoll_timeoutcommandtosettheamountoftimetheWirelessAPwillwaitforaresponse
timefromtheEnterasysWirelessControllerbeforerebooting.Thepoll_timeoutcommandis
accessiblefromtheap
:defaults:dualbandcontextoftheCLI.
Syntax
poll_timeout <value>
Parameters
Examples
Thefollowingexamplesetsthepolltimeoutto20seconds
EWC.enterasys.com:ap:defaults:dualband# poll_timeout 20
4.3.4.8 radio1
Theradio1commandreferstotheradio1context,whichcontainscommandstoconfigureRadio1
oftheWirelessAP.Theradio1commandisaccessiblefromtheap
:defaults:dualbandcontextofthe
CLI.
Thefollowingcommandsareavailableintheap
:defaults:dualband:radio1context:
• admin‐mode
• atpc
• beaconp
• dcs—Seedcsforcommandsintheap:defaults:dualband:radio1:dcscontext.
• divrx
• divtx
• domain
• dtim
Note: After you have run the persistent command, you must run the apply command to implement
the change in mode persistence value.
Note: The acceptable range for poll_timeout value is from 3 to 600.
<value> Specifiestheamountoftime,inseconds,towaitforaresponsefrom
theEnterasysWirelessControllerbeforerebooting.
Note: After you have run the poll_timeout command, you must run the apply command to
implement the change in poll timeout value.