Specifications

4-70 ap Commands
4.3.4.5 lldp
UsethelldpcommandtoenablethebroadcastoftheLLDPprotocolbyaWirelessAP.Usetheno
formofthecommandtodisableLLDP.Thelldpcommandisaccessiblefromthe
ap
:defaults:dualbandcontextoftheCLI.
Syntax
lldp <Announcement Interval> <Announcement Delay>
no lldp
Parameters
Examples
ThefollowingexampleenablesLLDPforthedefaultWirelessAPconfigurationwithan
announcementintervalof30seconds,andanannouncementdelayof2.
EWC.enterasys.com:ap:defaults:dualband# lldp 30 2
IfSNMPisenabledtopublishontheEnterasysWirelessControllerandyouenableLLDP,the
followingmessageisdisplayed:
WARNING: SNMP is set to publish. How Do you wish to continue?
(C) Cancel
(P) Proceed
(O) Disable SNMP publishing and proceed
Typeoneofthefollowing:
• C–CancelstheLLDPconfigurationandreturnstotheAPcontext.
• P–EnablesLLDPandmaintainsSNMPrunning
• O–EnablesLLDPanddisablesSNMPpublishing
4.3.4.6 persistent
Usethepersistentcommandtoenablemodepersistence.Usethenoformofthecommandto
disablethefeature.Thepersistentcommandisaccessiblefromtheap
:defaults:dualbandcontextof
theCLI.
Syntax
persistent
no persistent
Parameters
None
<AnnouncementInterval> Specifiesthescheduledfrequency,measuredinseconds,in
whichtheWirelessAPadvertisesitsinformationby
sendinganewLLDPpacket.
<AnnouncementDelay> Specifiesthedelay,measuredinseconds,between
successiveLLDPframetransmissionsthatisinitiatedbya
value/statuschangeintheLLDPlocalsystemsMIB.