Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-69
4.3.4.3 country
UsethecountrycommandtospecifythecountrytheWirelessAPresidesin.Thecountry
commandisaccessiblefromtheap
:defaults:dualbandcontextoftheCLI.
Syntax
country <country_name>
Parameters
Examples
ThefollowingexamplesetsthenameofthecountrytoUnitedStates.
EWC.enterasys.com:ap:defaults:dualband# country United States
4.3.4.4 led-mode
Usetheled‐modecommandtoconfigurethebehavioroftheLEDsontheWirelessAP.Theled‐
modecommandisaccessiblefromtheap
:defaults:dualbandcontextoftheCLI.
Syntax
led-mode off | normal
Parameters
Examples
ThefollowingexampleturnsoffLEDactivity:
EWC.enterasys.com:ap:defaults:dualband# led-mode off
Note: After you have run the client_session command, you must run the apply command to
implement the change in client session.
<country_name> Specifiesthenameofthecountry
Note: After you have run the country command, you must run the apply command to implement
the change in country.
off Displaysfaultpatternsonly.LEDsdonotlightwhentheAP
isfaultfreeandthediscoveryiscomplete.
normal IdentifiestheAPstatusduringtheregistrationprocess
duringpoweronandbootprocess.