Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-57
Parameters
Examples
ThefollowingexampledisablesatpconRadio2.
EWC.enterasys.com:ap:defaults:4102:radio2# no atpc maintain_power
4.3.2.9.3 beaconp
Usethebeaconpcommandtosettimeunitsbetweenbeacontransmissions.Thebeaconp
commandisaccessiblefromtheap
:defaults:4102:radio2contextoftheCLI.
Syntax
beaconp <value>
Parameters
Examples
Thefollowingexamplesetsthetimebetweensuccessivebeaconsto70msonRadio2.
EWC.enterasys.com:ap:defaults:4102:radio2# beaconp 70
4.3.2.9.4 dcs
Thedcscommandreferstothedcscontext,whichcontainscommandstoconfiguretheDynamic
ChannelSelection(DCS)feature.Thedcscommandisaccessiblefromtheap
:defaults:4102:radio2
contextoftheCLI.
Thefollowingcommandsareavailableintheap
:defaults:4102:radio2:dcscontext:
• channel_plan
• mode
• radio_channels
4.3.2.9.4.1 channel_plan
Usethechannel_plancommandtocustomizethechannelplanfortheWirelessAP’sradio2.The
channel_plancommandisaccessiblefromtheap:defaults:4102:radio2:dcscontextoftheCLI.
Syntax
channel_plan <auto|3-channel|4-channel|channel[, channel]>
[maintain_power] WhenyoudisableATPC,youcan electtomaintainusingthe
currentTxpowersettingATPChadestablished.
<value> Specifiesthenumberoftimeunits(milliseconds)betweenbeacon
transmissions.Theacceptablerangeforbeaconpvalueisfrom50to
1000milliseconds.
Note: Commands entered in the dcs context do not need to be followed by "apply" in order for them
to take effect.