Specifications

4-46 ap Commands
4.3.2.8.1 admin-mode
Usethiscommenttoconfiguretheadministrationstatusfortheradio.Theadmin‐modecommand
isaccessiblefromtheap:defaults:4102:radio1contextoftheCLI.
Syntax
admin-mode off|on
Parameters
Examples
EWC.enterasys.com:ap:defaults:4102:radio1# admin-mode on
4.3.2.8.2 atpc
UsetheatpccommandtoenableAutoTxPowerCtrl(ATPC).Usethenoformofthecommandto
disablethefeature.Theatpccommandisaccessiblefromtheap
:defaults:4102:radio1contextofthe
CLI.
Syntax
atpc
no atpc [maintain_power]
Parameters
Examples
ThefollowingexampledisablesatpconRadio1.
EWC.enterasys.com:ap:defaults:4102:radio1# no atpc maintain_power
4.3.2.8.3 beaconp
Usethebeaconpcommandtosettimeunitsbetweenbeacontransmissions.Thebeaconp
commandisaccessiblefromtheap
:defaults:4102:radio1contextoftheCLI.
Syntax
beaconp <value>
Parameters
off Cleartheadministrativestatus.
on Settheadministrativestatus.Onisthe default.
[maintain_power] WhenyoudisableATPC,youcan electtomaintainusingthe
currentTxpowersettingATPChadestablished.
<value> Specifiesthenumberoftimeunits(milliseconds)betweenbeacon
transmissions.Theacceptablerangeforbeaconpvalueisfrom50to
1000milliseconds.