Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-45
Parameters
Examples
Thefollowingexamplesetsthepolltimeoutto20seconds
EWC.enterasys.com:ap:defaults:4102# poll_timeout 20
4.3.2.8 radio1
Theradio1commandreferstotheradio1context,whichcontainscommandstoconfigureRadio1
oftheWirelessAP.Theradio1commandisaccessiblefromtheap
:defaults:4102contextoftheCLI.
Thefollowingcommandsareavailableintheap
:defaults:4102:radio1context:
• admin‐mode
• atpc
• beaconp
• dcs—Seedcsforcommandsintheap:defaults:4102:radio1:dcscontext.
• divrx
• divtx
• domain
• dtim
• frag
• hwretries
• maxbrate
• maxoprate
• max‐distance
• minbrate
• mode
• rts
• tx_adjust_power
• tx_max_power
• tx_min_power
<value> Specifiestheamountoftime,inseconds,towaitforaresponsefrom
theEnterasysWirelessControllerbeforerebooting.
Note: After you have run the poll_timeout command, you must run the apply command to
implement the change in poll timeout value.