Specifications
4-44 ap Commands
Examples
ThefollowingexampleenablesLLDPforthedefaultWirelessAPconfigurationwithan
announcementintervalof30seconds,andanannouncementdelayof2.
EWC.enterasys.com:ap:defaults:4102# lldp 30 2
IfSNMPisenabledtopublishontheEnterasysWirelessControllerandyouenableLLDP,the
followingmessageisdisplayed:
WARNING: SNMP is set to publish. How Do you wish to continue?
(C) Cancel
(P) Proceed
(O) Disable SNMP publishing and proceed
Typeoneofthefollowing:
• C–CancelstheLLDPconfigurationandreturnstotheAPcontext.
• P–EnablesLLDPandmaintainsSNMPrunning
• O–EnablesLLDPanddisablesSNMPpublishing
4.3.2.6 persistent
Usethepersistentcommandtoenablemodepersistence.Usethenoformofthecommandto
disablethefeature.Thepersistentcommandisaccessiblefromtheap
:defaults:4102contextofthe
CLI.
Syntax
persistent
no persistent
Parameters
None
Examples
Thefollowingexampleenablesmodepersistence.
EWC.enterasys.com:ap:defaults:4102# persistent
4.3.2.7 poll_timeout
Usethepoll_timeoutcommandtosettheamountoftimetheWirelessAPwillwaitforaresponse
timefromtheEnterasysWirelessControllerbeforerebooting.Thepoll_timeoutcommandis
accessiblefromtheap
:defaults:4102contextoftheCLI.
Syntax
poll_timeout <value>
Note: After you have run the persistent command, you must run the apply command to implement
the change in mode persistence value.
Note: The acceptable range for poll_timeout value is from 3 to 600.