Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-43
Examples
ThefollowingexamplesetsthenameofthecountrytoUnitedStates.
EWC.enterasys.com:ap:defaults:4102# country United States
4.3.2.4 led-mode
Usetheled‐modecommandtoconfigurethebehavioroftheLEDsontheWirelessAP.Theled‐
modecommandisaccessiblefromtheap
:defaults:4102contextoftheCLI.
Syntax
led-mode off | normal
Parameters
Examples
ThefollowingexampleturnsoffLEDactivity:
EWC.enterasys.com:ap:defaults:4102# led-mode off
4.3.2.5 lldp
UsethelldpcommandtoenablethebroadcastoftheLLDPprotocolbyaWirelessAP.Usetheno
formofthecommandtodisableLLDP.Thelldpcommandisaccessiblefromtheap
:defaults:4102
contextoftheCLI.
Syntax
lldp <Announcement Interval> <Announcement Delay>
no lldp
Parameters
Note: After you have run the country command, you must run the apply command to implement
the change in country.
off Displaysfaultpatternsonly.LEDsdonotlightwhentheAP
isfaultfreeandthediscoveryiscomplete.
normal IdentifiestheAPstatusduringtheregistrationprocess
duringpoweronandbootprocess.
<AnnouncementInterval> Specifiesthescheduledfrequency,measuredinseconds,in
whichtheWirelessAPadvertisesitsinformationby
sendinganewLLDPpacket.
<AnnouncementDelay> Specifiesthedelay,measuredinseconds,between
successiveLLDPframetransmissionsthatisinitiatedbya
value/statuschangeintheLLDPlocalsystemsMIB.