Specifications

4-32 ap Commands
Validvaluesfor<min‐rate>dependontheradiomodeandareexpressedasMbps:
Usage
Theminimumbasicratemustbelowerthanorequattotheconfiguredmaximumbasicdatarate
andmaximumdatarate thatclientscanoperateatwhileassociatedwiththeAP.
Examples
Thisexamplesetsthemodeforradio2tog,thensetstheminimumbasicdatarateto12Mbps.
EWC.enterasys.com:ap:defaults:11n:radio2# mode g
EWC.enterasys.com:ap:defaults:11n:radio2# minbrate 12
4.3.1.10.11 mode
UsethemodecommandtosettheradiooptionsforRadio2.Usethenoformofthecommandto
disableRadio2.Themodecommandisaccessiblefromtheap:defaults:11n:radio2contextofthe
CLI.
Syntax
mode b|g|gn|n-strict|bg|bgn
Parameters
Radio Mode Minimum Basic Rate Range per Mode
b 1, 2, 5.5, 11
g 6, 12, 24
gn 6, 12, 24
n-strict 6, 12, 24, MCS0 – MCS7
bg 1, 2, 5.5, 11
bgn 1, 2, 5.5, 11
Note: Depending on the radio mode you select, some of the radio settings may not be available for
configuration.
bEnablesthe802.11b‐onlymodeofRadio2.Ifenabled,theAPwilluse
only11b(CCK)rateswithallassociatedclients.
gEnablesthe802.11g‐onlymodeofRadio2.TheAPwilluse11g ‐only
(OFDM)rateswithallassociatedclients.
gn Enablesboththe802.11gmodeandthe802.11nmodeof
Radio2.If
selected,theAPwilluse11nand11g‐specific(OFDM)rateswithallof
theassociatedclients.TheAPwillnottransmitorreceive11brates.
n‐strict Enablesthe802.11n ‐strictmodeofRadio2.Ifselected,theAPwilluse
11nand(optionally)11grateswith
alloftheassociatedclients.TheAP
willnottransmitorreceive11brates..
bg Enablesboththe802.11gmodeandthe802.11bmodeofRadio2.If
enabled,theAPwilluse11b(CCK)and11g‐specific(OFDM)rates
withalloftheassociatedclients.TheAPwillnottra nsmitor
receive
11nrates.