Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-31
thatarelessthanorequaltothislimit.Thefragcommandisaccessiblefromthe
ap:defaults:11n:radio2contextoftheCLI.
Syntax
frag <value>
Parameters
Examples
Thefollowingexamplesetsthefragmentationthreshol dto1500
EWC.enterasys.com:ap:defaults:11n:radio2# frag 1500
4.3.1.10.9 max-distance
Usethemax‐distancecommandtosetthemaximumlinkdistance, inmeters,betweenAPsthat
participateinaWDS.Thisvalueensuresthattheacknowledgementofcommunicationbetween
APsdoesnotexceedthetimeoutvaluepredefinedbythe802.11standard.
Ifthelinkdistance
betweenAPsisgreaterthanthedefaultvalueof100meters,configurethemaximumdistanceup
to15,000meterssothatthesoftwareincreasesthetimeoutvalueproportionallywiththedistance
betweenAPs.Themax‐distancecommandisaccessiblefromtheap:defaults:11n:radio2contextof
theCLI.
Syntax
max-distance <value>
Parameters
Examples
ThefollowingexamplesetsthemaximumdistancebetweenAPsto1500meters.
EWC.enterasys.com:ap:defaults:11n:radio2# max-distance 1500
4.3.1.10.10 minbrate
Usethiscommandtoconfiguretheminimumbasicdatarateforradio2.Theminbratecommand
isaccessiblefromtheap:defaults:11n:radio2contextoftheCLI.
Syntax
minbrate <min-rate>
Parameters
<value> Specifiesthemaximumsize,measuredinbytes,ofanypacket
fragmentfordelivery.
Note: Do not change the default setting for any radio that is not participating in a Mesh or WDS.
<value> SpecifiesthemaximumdistancebetweenAPsinmeters.Thedefaultis
100meters.Youcanenteravaluefrom100to15000meters.