Specifications
Enterasys Wireless Controller Software CLI Reference Guide 4-29
4.3.1.10.5.2 mode
UsethemodecommandtosettheDCSmode.Themodecommandisaccessiblefromthe
ap:defaults:11n:radio2:dcscontextoftheCLI.
Syntax
mode <off|monitor|active>
Parameters
Examples
ThefollowingexamplesetsDCStoactivemode.
EWC.enterasys.com:ap:defaults:11n:radio2:dcs# mode active
4.3.1.10.5.3 radio_channels
Usetheradio_channelscommandtodisplaythelistofavailableradiochannelsforautochannel
selection(ACS).Theradio_channelscommandisaccessiblefromtheap:defaults:11n:radio2:dcs
contextoftheCLI.
Syntax
radio_channels
Parameters
None
Examples
EWC.enterasys.com:ap:defaults:11n:radio1:dcs# radio_channels
Available radio channels:
1: 2412 MHz
2: 2417 MHz
3: 2422 MHz
4: 2427 MHz
5: 2432 MHz
6: 2437 MHz
7: 2442 MHz
8: 2447 MHz
9: 2452 MHz
10: 2457 MHz
off DisablesDCS
monitor Monitorsthenoiseandinterferenceonthecurrentchannel
active EnablesDCS
Note: In monitor mode, DCS generates an alarm and does not change the channel if the noise and
interference levels on the current channel exceed beyond their thresholds. In active mode, DCS
changes the channel if the noise and interference levels on the current channel exceed beyond
their thresholds.