Specifications

4-28 ap Commands
Parameters
Examples
Thefollowingexamplesetsthetimebetweensuccessivebeaconsto70msonRadio2.
EWC.enterasys.com:ap:defaults:11n:radio2# beaconp 70
4.3.1.10.5 dcs
Thedcscommandreferstothedcscontext,whichcontainscommandstoconfiguretheDynamic
ChannelSelection(DCS)feature.Thedcscommandisaccessiblefromtheap
:defaults:11n:radio2
contextoftheCLI.
Thefollowingcommandsareavailableintheap
:defaults:11n:radio2:dcscontext:
• channel_plan
• mode
• radio_channels
4.3.1.10.5.1 channel_plan
Usethechannel_plancommandtocustomizethechannelplanfortheWirelessAP’sRadio2.The
channel_plancommandisaccessiblefromtheap:defaults:11n:rad io2:dcscontextoftheCLI.
Syntax
channel_plan <auto|3-channel|4-channel|channel[, channel]>
Parameters
Example
Thefollowingexampleshowsthatthechannelplanforradio2iscustomizedtoinclud e channels
1,2and3.
EWC.enterasys.com:ap:defaults:11n:radio2:dcs# channel_plan 1, 2, 3
<value> Specifiesthenumberoftimeunits(milliseconds)betweenbeacon
transmissions.Theacceptablerangeforbeaconpvalueisfrom50to
1000milliseconds.
Note: Commands entered in the dcs context do not need to be followed by "apply" in order for them
to take effect.
Note: The parameters available in the channel_plan command are determined by the setting of
the mode command in the ap:defaults:11n:radio2 context.
auto Radio2uses3channelsforcountriessupporting11channelsand4
channelsforcountriessupporting13channels.
3‐channel Radio2uses3channels.
4‐channel Radio2uses4channels.
channel[,channel] Radio2usesthechannelsthatarelisted,separatedbycommas.