Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-21
4.3.1.9.18 n_chlbonding
Usethen_chlbondingcommandtospecifythechannelbondingtype—upordown.The
n_chlbondingcommandisaccessiblefromtheap:defaults:11n:radio1contextoftheCLI.
Syntax
n_chlbonding (up|down)
Parameters
Examples
Thefollowingexamplesetsthechannelbondingtypeasup.
EWC.enterasys.com:ap:defaults:11n:radio1# n_chlbonding up
4.3.1.9.19 n_chlwidth
Usethen_chlwidthcommandtospecifythe802.11nchannelwidth—20MHzor40MHz.This
commandonlyhaseffectwhenthemodeissettoenable802.11n.Then_chlwidthcommandis
accessiblefromtheap:defaults:11n:radio1 contextoftheCLI.
Syntax
n_chlwidth (20|40|auto)
Parameters
Examples
Thefollowingexamplesetsthechannelwidthto40MHz.
EWC.enterasys.com:ap:defaults:11n:radio1# n_chlwidth 40
up Theprimarychannel(20MHz)isbondedwithanextension
channelthatis20MHzabove(bondingup)theprimarychannel.
down Theprimarychannel(20MHz)isbondedwithanextension
channelthatis20MHzbelow(bondingdown)theprimary
channel.
Note: Depending on the channel you have selected, you may be prevented from bonding up or
down. For more information, see the Enterasys Wireless Controller, Access Points and
Convergence Software User Guide.
20 Specifiesthechannelwidthas20MHz
40 Specifiesthechannelwidthas40MHz
auto SpecifiesthattheAPwillautomaticallyselectthechannel
widthdependinguponhowbusytheextensionchannelis.The
extensionchannelthresholdissetviathen_pbthreshold
command.