Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-17
Parameters
Examples
Thefollowingexamplesetsthefragmentationthreshol dto1500
EWC.enterasys.com:ap:defaults:11n:radio1# frag 1500
4.3.1.9.9 max-distance
Usethemax‐distancecommandtosetthemaximumlinkdistance, inmeters,betweenAPsthat
participateinaWDS.Thisvalueensuresthattheacknowledgementofcommunicationbetween
APsdoesnotexceedthetimeoutvaluepredefinedbythe802.11standard.
Ifthelinkdistance
betweenAPsisgreaterthanthedefaultvalueof100meters,configurethemaximumdistanceup
to15000meterssothatthesoftwareincreasesthetimeoutvalueproportionallywiththedistance
betweenAPs.Themax‐distancecommandisaccessiblefromtheap:defaults:11n:radio1contextof
theCLI.
Syntax
max-distance <value>
Parameters
Examples
ThefollowingexamplesetsthemaximumdistancebetweenAPsto1500meters.
EWC.enterasys.com:ap:defaults:11n:radio1# max-distance 1500
4.3.1.9.10 minbrate
Usethiscommandtoconfiguretheminimumbasicdatarateforradio1.Theminbratecommand
isaccessiblefromtheap:defaults:11n:radio1contextoftheCLI.
Syntax
minbrate <min-rate>
Parameters
Validvaluesfor<min‐rate>dependontheradiomodeandareexpressedasMbps:
<value> Specifiesthemaximumsize,measuredinbytes,ofanypacket
fragmentfordelivery.
Rangeis256to2346.
Note: Do not change the default setting for the radio that provides service to 802.11 clients only.
value SpecifiesthemaximumdistancebetweenAPsinmeters.Thedefaultis
100meters.Youcanenteravaluefrom100to15000meters.