Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-13
Examples
ThefollowingexampleshowsthechannelplanforRadio1isconfiguredtoincludeallnon‐DFS
channels.
EWC.enterasys.com:ap:defaults:11n:radio1:dcs# channel_plan all-non-dfs
Thefollowingexampleshowsthatthechannelplanforradio1iscustomizedtoincludechannels1,
2and3..
EWC.enterasys.com:ap:defaults:11n:radio1:dcs# channel_plan 1, 2, 3
4.3.1.9.5.2 mode
UsethemodecommandtosettheDCSmode.Themodecommandisaccessiblefromthe
ap:defaults:11n:radio1:dcscontextoftheCLI.
Syntax
mode <off|monitor|active>
Parameters
Examples
ThefollowingexamplesetsDCStoactivemode.
EWC.enterasys.com:ap:defaults:11n:radio1:dcs# mode active
4.3.1.9.5.3 noise_threshold
Usethenoise_thresholdcommandtosettheDCSnoisethreshold.Thenoise_threshold
commandisaccessiblefromtheap:defaults:11n:radio1:dcscontextoftheCLI.
Syntax
noise_threshold <thrshold>
Parameters
off DisablesDCS
monitor Monitorsthenoiseandinterferenceonthecurrentchannel
active EnablesDCS
Note: In monitor mode, DCS generates an alarm and does not change the channel if the noise and
interference levels on the current channel exceed beyond their thresholds. In active mode, DCS
changes the channel if the noise and interference levels on the current channel exceed beyond
their thresholds.
<thrshold> SpecifiestheDCSnoisethresholdindBm.TheDCSnoise
thresholdmustbeinthe‐95to‐50range.ACSwillscanfor
anewoperatingchannelfortheWirelessAPifthe
thresholdisexceeded.