Specifications

4-12 ap Commands
Parameters
Examples
Thefollowingexamplesetsthetimebetweensuccessivebeaconsto70msonRadio1.
EWC.enterasys.com:ap:defaults:11n:radio1# beaconp 70
4.3.1.9.5 dcs
Thedcscommandreferstothedcscontext,whichcontainscommandstoconfiguretheDynamic
ChannelSelection(DCS)feature.Thedcscommandisaccessiblefromtheap
:defaults:11n:radio1
contextoftheCLI.
Thefollowingcommandsareavailableintheap
:defaults:11n:radio1:dcscontext:
• channel_plan
• mode
• noise_threshold
• occupancy_threshold
• radio_channels
• update_period
4.3.1.9.5.1 channel_plan
Usethechannel_plancommandtocustomizethechannelplanfortheWirelessAP’sRadio1.The
channel_plancommandisaccessiblefromtheap:defaults:11n:rad io1:dcscontextoftheCLI.
Syntax
channel_plan <all-non-dfs|all|channel[, channel]>
Parameters
<value> Specifiesthenumberoftimeunits(milliseconds)betweenbeacon
transmissions.Theacceptablerangeforbeaconpvalueisfrom50to
1000milliseconds.
Note: After you have run the beaconp command, you must run the apply command to implement
the change.
Note: Commands entered in the dcs context do not need to be followed by "apply" in order for them
to take effect.
Note: The parameters available in the channel_plan command are determined by the setting of
the mode command in the ap:defaults:11n:radio1 context.
all‐non‐dfs Radio1usesallnon‐DFSchannels.
all Radio1usesallchannels
channel[,channel] Radio1usesthechannelsthatarelisted,separatedby
commas.