Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-11
Examples
ThefollowingexampledepictsRadio1oftheWireless802.11nAPconfiguredtousetheleft‐middle‐
rightantennacombination.
EWC.enterasys.com:ap:defaults:11n:radio1# antsel left-middle-right
4.3.1.9.3 atpc
UsetheatpccommandtoenableAutoTxPowerCtrl(ATPC).Usethenoformofthecommandto
disablethefeature.Theatpccommandisaccessiblefromtheap:defaults:11n:radio1contextofthe
CLI.
Syntax
atpc
no atpc [maintain_power]
Parameters
Examples
ThefollowingexampledisablesatpconRadio1.
EWC.enterasys.com:ap:defaults:11n:radio1# no atpc maintain_power
4.3.1.9.4 beaconp
Usethebeaconpcommandtosettimeunitsbetweenbeacontransmissions.Thebeaconp
commandisaccessiblefromtheap:defaults:11n:radio1contextoftheCLI.
Syntax
beaconp <value>
left‐middle Specifiestheuseoftheleft‐middleantennacombinationon
theWireless802.11nAP.
left‐right Specifiestheuseofthe left‐rightantennacombinationon
theWireless802.11nAP.
middle‐right Specifiestheuseofthemiddle‐rightantennacombination
ontheWireless802.11nAP.
left‐middle‐right Specifiestheuseofthe
left‐middle‐rightantenna
combinationontheWireless802.11nAP.
Note: After you have run the antsel command, you must run the apply command to implement the
change.
[maintain_power] WhenyoudisableATPC,youcan electtomaintainusingthe
currentTxpowersettingATPChadestablished.
Note: After you have run the atpc command, you must run the apply command to implement the
change.