Specifications

Enterasys Wireless Controller Software CLI Reference Guide 4-9
4.3.1.8 poll_timeout
Usethepoll_timeoutcommandtosettheamountoftimetheWirelessAPwillwaitforaresponse
fromtheEnterasysWirelessControllerbeforerebooting.Thepoll_timeoutcommandisaccessible
fromtheap
:defaults:11ncontextoftheCLI.
Syntax
poll_timeout <value>
Parameters
Examples
Thefollowingexamplesetsthepolltimeoutto20seconds
EWC.enterasys.com:ap:defaults:11n# poll_timeout 20
4.3.1.9 radio1
Theradio1commandreferstotheradio1context,whichcontainscommandstoconfigureRadio1
oftheWirelessAP.Theradio1commandisaccessiblefromtheap
:defaults:11ncontextoftheCLI.
Thefollowingcommandsareavailableintheap
:defaults:11n:radio1context:
• admin‐mode
• antsel
• atpc
• beaconp
• dcs—Seedcsforcommandsintheap:defaults:11n:radio1:dcscontext.
• domain
• dtim
• frag
• max‐distance
• minbrate
• mode
• n_addba_support
• n_aggr_mpdu
• n_aggr_mpdu_max
• n_aggr_mpdu_max_subframes
Note: The acceptable range for poll_timeout value is from 3 to 600.
<value> Specifiestheamountoftime,inseconds,towaitforaresponsefrom
theEnterasysWirelessControllerbeforerebooting.
Note: After you have run the poll_timeout command, you must run the apply command to
implement the change in poll timeout value.