Specifications

4-8 ap Commands
Examples
ThefollowingexampleenablesLLDPforthedefaultWirelessAPconfigurationwithan
announcementintervalof30seconds,andanannouncementdelayof2.
EWC.enterasys.com:ap:defaults:11n# lldp 30 2
IfSNMPisenabledtopublishontheEnterasysWirelessControllerandyouenableLLDP,the
followingmessageisdisplayed:
WARNING: SNMP is set to publish. How Do you wish to continue?
(C) Cancel
(P) Proceed
(O) Disable SNMP publishing and proceed
Typeoneofthefollowing:
• C–CancelstheLLDPconfigurationandreturnstotheAPcontext.
• P–EnablesLLDPandmaintainsSNMPrunning
• O–EnablesLLDPanddisablesSNMPpublishing
4.3.1.7 persistent
Usethepersistentcommandtoenablemodepersistence.Usethenoformofthecommandto
disablethefeature.Thepersistentcommandisaccessiblefromtheap
:defaults:11ncontextofthe
CLI.
Syntax
persistent
no persistent
Parameters
None
Examples
Thefollowingexampleenablesmodepersistence.
EWC.enterasys.com:ap:defaults:11n# persistent
<AnnouncementDelay> Specifiesthedelay,measuredinseconds,between
successiveLLDPframetransmissionsthatisinitiatedbya
value/statuschangeintheLLDPlocalsystemsMIB.Range
is1to1/4xAnnouncementIntervalvalue.
Note: After you have run the persistent command, you must run the apply command to implement
the change in mode persistence value.