User`s guide

Release Notes Inter-operability with Third-Party VPN Gateways
Release 3.5 Enhanced Support for VPN Clients
Rel. 3.5 Release Notes Page 23 of 30
! Enter Cisco_Peer in the VPN Connection Name field.
! Set the public IP address of the Cisco device. Type 146.115.206.35 in the
Gateway IP address field.
! Enter testing as a Password. This value must match the value configured for
the Cisco device.
! Select Peer to Peer Mode.
! Type 10.120.54.0/24 in the first Peer Subnet address and Mask fields. This
value must match the trusted subnet of the Cisco device.
! Checkmark Start network gateway now and click
APPLY.
Connecting to the Nortel Contivity CES 600 Switch
The following instructions are provided to configure a Peer to Peer tunnel between a
Nortel Contivity Extranet Switch and the ANG-1100.
8. At the main menu, click to PROFILES> Networks.
– Create a new profile: Trusted_lan which defines your internal network.
– Enter a new subnet: 10.122.54.0/24.
– Click
ADD.
9. Add a Group.
– Click to PROFILES > Branch Office > Add Group.
– Enter the Group Name/BaseGroup of Peer2Peer.
– Click
OK.
10. Edit Group Peer2Peer.
– Select Configure = Idle Time - Enter 00:00:00.
– Click
OK.
– Select Configure IPSEC - Enable ESP-Triple DES w/SHA Disable Vendor
ID and Disable Perfect Forward Secrecy.
– Click
OK.
– Click
CLOSE.
11. Define a Branch Office Connection for the group just created.
– Click to Define Branch Office Connection.
– Enter Name & Group
– Click
OK.
– Enter 146.115.206.35 as the Local Peer IP Address - Public IP address of
the CES.
– Enter the Remote Peer Address.
– Enter the Pre-shared Keys.
– Click
CONTINUE.
– Click
ENTER REMOTE.
12. Select Trusted LAN information - Static.
– Enter Remote 10.121.210.0/ MASK / State / Cost.
– Click ON.
– Select No NAT Translation selected from the pull-down menu.