User`s guide

36 XSR User’s Guide

Utilizing the Command Line Interface Chapter 2

Managing the XSR

In summary, when upgrading 1.x to 2.x Bootrom versions only, you must run

the

bU command twice - first with the bootrom_uncmp.fls file, then with the

upgraded Bootrom. Between upgrades you must reboot using

bw..

To upgrade your firmware using the Local Bootrom Upgrade, perform the

following steps:

1 Power on the XSR by flipping the rear switch and observe the front

LEDs. When the system, VPN, console, NIM1 and NIM2 LEDs turn

off, immediately enter <Ctrl-C> on the terminal. If you miss this time

window, power off and try again. The Bootrom monitor menu should

appear as follows:

X-Pedition Security Router Bootrom

HW Version: 9002854-02 REV0A Serial Number: 2854019876543210

CPU: IBM PowerPC 405GP Rev. D

VxWorks version: 5.4

Bootrom version: 1.21

Creation date: Nov 3, 2002, 11:16:44

Cold Start: SystemReset from powerup

Password:

Entering ROM monitor Type "h" for help

Using default Bootrom password The system is not secure!!!

Use "bp" to change password

XSR1800:

2 Type h or ? to display the command groups.

3 Type f to list the file command group.

4 Type n to list the network command group.

5 Using the np command, assign the following:

– Local IP address (of the XSR).

– Remote (host computer) IP address (The host must be on the

same subnet as the XSR).

– DOS-style full path (without the file name) of the site of the

Bootrom file on the host computer.

– The username and password to use when connecting to your FTP

server on the host computer.